If your code is correct, you will be connected to Ceres’ data transfer node.
Ssh the verification code currently displayed in Google Authenticator, then enter your SCINet password. To verify the application is working correctly, Make sure you’ve chosen to make the key time-based and press “Save.” Select Enter a provided key, then Enter account name, which is Next, enter the Google Authenticator key from the “Welcome to Ceres” email into the box under Enter Key. Once the app is installed, reopen Google Authenticator, display QR code on your computer by clicking on the link in the “Welcome to Ceres” email and point your camera at the QR code.
If you want to install a barcode scanner app so you can complete the setup process, press Install then go through the installation process. If the Authenticator app cannot locate a barcode scanner app on your phone, you might be prompted to download and install one. An alternative would be to use a Google Authenticator key as mentioned on the above screenshot. Using QR code is easier but requires a barcode scanner which you can install if you don’t have it yet (Google Authenticator app will prompt you to install it). There are two ways to link your device to your account. If you already use the app and are adding a new account, choose “Add an account” from the app’s menu. If this is the first time you have used Authenticator, click the Add an account button. Open the Google authenticator app on your mobile device.
To use Google Authenticator on your Android device, it must be running Android version 2.1 or later (other TOTP authenticators can be used if you prefer). Google Authenticator (GA) on Android Requirements After resetting your GA account you will receive an email containing a key/code that should be used to initialize GA on your mobile device.įollow the instructions below to set up multifactor authentication on either your mobile Android device (recommended), Apple device (recommended), or on your computer. If you have already had GA installed and initialized but now need to either re-install GA or install it on a new device, and if you saved your SMS phone number in the system, you can reset GA account by going to. Ssh the first attempt a GA account will be created for you and you will receive an email containing a key/code that should be used to initialize GA on your mobile device. Note: If your SCINet account was created before January 2020, and a GA account was never created, attempt to login to the Ceres DTN node: To add your SCINet GA account to the app, you will need a key or a QR code, that you can find in your “Welcome to Ceres” email. The app is initialized with your SCINet Google Authentication (GA) account, that is normally created along with your SCINet account. You will need to install an app on a mobile device or a small program on your computer that will generate your verification codes. It’s also needed to connect to SCINet VPN. However the code is always required to ssh to the Atlas cluster and to use other SCINet resources, such as SCINet Galaxy or SCINet Forum.
If you’re ssh-ing to Ceres cluster from a connected site (where you already had to use second factor such as PIV/CAC), you probably won’t be prompted for a verification code. This means that a code is required in addition to a password to login to SCINet. Authentication on Your Computer Using Authyįederal computer systems are required to use multifactor authentication for site security.Google Authenticator on Apple iOS iPhones and iPads.Multifactor Authentication Table of Contents